Device Location IP Address Template
This template imports a predefined context that defines the location of a remote device based on its IP address, and can be used as a building block in your configuration. It can be found in the BUILDING BLOCKS category when filtered for REMOTE platform.
deviceTRUST requires some simple but essential configuration steps to be performed to enable the template for your remoting and DaaS environments. We will guide you step-by-step through simple deviceTRUST configuration steps to enable the template within your remoting or DaaS environment.
We will perform the following steps:
Step 1: Prerequisites
If the required deviceTRUST components (Agent, Console, Client Extension and License) are not yet installed, please visit the Getting Started for Remote guide and complete step 1 to 5 and then continue here with step 2 below.
Step 2: Context
The template has imported the following context:
| Context | Description | Customizations |
|---|---|---|
| Device Location
|
Defines the location of a remote device based on its IP address.
|
You must update the following context condition with data suitable for your environment:
REMOTE - NETWORK IPV4 SUBNET IPv4 Range From 1.1.1.1 to 1.1.1.254,…
Replace the IPv4 range for Floor 1, Floor 2, Floor 3,… with the IPv4 range representing the target location. Example: 1.1.1.1 to 1.1.1.254 |
Troubleshooting
If your deviceTRUST installation or configuration does not work as expected, you can use the Troubleshooting guide to start troubleshooting.