Secure Screen Saver Template
This template creates a configuration that locks the session if the session becomes idle and the remote devices does not have a secure screen saver configured. It can be found in the
DYNAMIC POLICY category when filtered for
deviceTRUST requires some simple but essential configuration steps to be performed to enable the template for your remoting and DaaS environments. We will guide you step-by-step through simple deviceTRUST configuration steps to enable the template within your remoting or DaaS environment.
We will perform the following steps:
Step 1: Prerequisites
If the required deviceTRUST components (Agent, Console, Client Extension and License) are not yet installed, please visit the Getting Started for Remoting and DaaS guide and complete step 1 to 5 and then continue here with step 2 below.
Step 2: Contexts
The template has imported the following contexts:
|Session Idle||Defines the idle state of the session based on the screen saver configuration of a remote device.||None|
- If a context is not needed, it can be deactivated or deleted. In addition, the corresponding task sequence within the relevant action must be deleted too.
Step 3: Actions
The template includes an enforcement action that actively controls access to the session. By default, the enforcement action is enabled.
|Session Idle - Conditional Access - Enforcement||Locks the session if the session becomes idle.||Activated||None|
- If the action has been disabled, the context will still be created.
If your deviceTRUST installation or configuration does not work as expected, you can use the Troubleshooting guide to start troubleshooting.