Session Lock based on Wi-Fi Security Mode Template
This template creates a configuration that locks the session if the session becomes idle based on the Wi-Fi security mode. It can be found in the DYNAMIC POLICY category when filtered for LOCAL platform.
deviceTRUST requires some simple but essential configuration steps to be performed to enable the template for your local environment. We will guide you step-by-step through simple deviceTRUST configuration steps to enable the template within your local environment.
We will perform the following steps:
Step 1: Prerequisites
If the required deviceTRUST components (Agent, Console and License) are not yet installed, please visit the Getting Started for Local guide and complete step 1 to 4 and then continue here with step 2 below.
Step 2: Contexts
The template has imported the following context:
| Context | Description | Customizations |
|---|---|---|
| Session Idle | Defines the session idle state of a device connected to a Wi-Fi network. | None |
- If a context is not needed, it can be deactivated or deleted. In addition, the corresponding task sequence within the relevant action must be deleted too.
Step 3: Actions
The template includes an enforcement action that actively controls access to the session. By default, the enforcement action is enabled.
| Action | Description | Default State | Customizations |
|---|---|---|---|
| Session Idle - Conditional Access - Enforcement | Locks the session if the session becomes idle. | Activated | None |
- If the action has been disabled, the context will still be created.
Troubleshooting
If your deviceTRUST installation or configuration does not work as expected, you can use the Troubleshooting guide to start troubleshooting.