IP Address Template

This template creates a configuration that locks the session after an idle period which differs between meeting rooms (30 minutes idle time) and other locations (10 minutes idle time) based on the IP address of the local device. It can be found in the MEETING ROOM category when filtered for LOCAL platform.

deviceTRUST requires some simple but essential configuration steps to be performed to enable the template for your local environment. We will guide you step-by-step through simple deviceTRUST configuration steps to enable the template within your local environment.

We will perform the following steps:

1. Step 1: Prerequisites
2. Step 2: Contexts
3. Step 3: Actions

Step 1: Prerequisites

If the required deviceTRUST components (Agent, Console and License) are not yet installed, please visit the Getting Started for Local guide and complete step 1 to 4 and then continue here with step 2 below.

Step 2: Contexts

The template has imported the following context:

Context	Description	Customizations
Session Idle	Defines if the session is idle. Differs between meeting rooms and other locations based on the IP address.	You must update the following context condition with data suitable for your environment: LOCAL - NETWORK IPV4 SUBNET IPv4 Range From 1.1.1.1 to 1.1.1.254 Replace the IPv4 range with your meeting room device IPv4 range. Example: 1.1.1.1 to 1.1.1.254

Step 3: Actions

The template includes an enforcement action that actively controls access to the session. By default, the enforcement action is enabled.

Action	Description	Default State	Customizations
Session Idle - Conditional Access - Enforcement	Locks the session if the session becomes idle.	Activated	None

Troubleshooting

If your deviceTRUST installation or configuration does not work as expected, you can use the Troubleshooting guide to start troubleshooting.