User Privileges Template
This template creates a configuration that checks the privileges of the user logged into the remote device. It can be found in the COMPLIANCE CHECK category when filtered for REMOTE platform.
If the privileges of the user logged into the remote device are privileged without protection, you can choose between two actions:
- Denies access to the session based on the privileges of the user logged into the remote device.
- Displays a message in the session based on the privileges of the user logged into the remote device.
deviceTRUST requires some simple but essential configuration steps to be performed to enable the template for your remoting and DaaS environments. We will guide you step-by-step through simple deviceTRUST configuration steps to enable the template within your remoting or DaaS environment.
We will perform the following steps:
Step 1: Prerequisites
If the required deviceTRUST components (Agent, Console, Client Extension and License) are not yet installed, please visit the Getting Started for Remote guide and complete step 1 to 5 and then continue here with step 2 below.
Step 2: Contexts
The template has imported the following contexts:
| Context | Description | Customizations |
|---|---|---|
| User Privileges | Defines the privileges of the user logged into the remote device. | None |
- If a context is not needed, it can be deactivated or deleted. In addition, the corresponding task sequence within the relevant action must be deleted too.
Step 3: Actions
The template includes a notifying action that displays a message to the user about a context status and an enforcement action that actively controls access to the session. By default, only the notifying action is enabled and the enforcement action is disabled.
| Action | Description | Default State | Customizations |
|---|---|---|---|
| User Privilege - Conditional Access - Enforcement | Denies access to the session based on the privileges of the user logged into the remote device. | Deactivated | None |
| User Privilege - Conditional Access - Notification | Displays a message in the session based on the privileges of the user logged into the remote device. | Activated | None |
- If both actions have been disabled, the contexts will still be created.
- If both actions have been activated, the deny access task will take priority over the displaying of the notification message.
Troubleshooting
If your deviceTRUST installation or configuration does not work as expected, you can use the Troubleshooting guide to start troubleshooting.